All configuration are currently in stock (For now..)
--------------------------------------------------------------------------------------------------------
Standard 10 inch M4 profile barrel as used on a variety of "10"ish" builds (10", 10.3", 10.5").. for example XM177, Commandos, Mk18, C8, etc.
Why choose this barrel?
- 10, 10.5 and 11.5 are the two most popular lengths for Pistol or SBR builds
- Standard length currently used by SOCOM
- Available in 1:7 or 1:9 twist rate
- Light Weight: 1.1 lbs
- Nitride (Melonite) coating - increased Barrel life and corrosion protection
- 10.5" is the shortest most folks can go and still install a suppressor
We offer this barrel in three levels of Assembly:
- Stripped Barrel (just the barrel)
- "F" or "non-F" FSB, no other parts (see Notes below on "Short Pinning")
- Full Barrel Assembly
- Tapper Pinned FSB - choice of "F-marked" or "non-F"
- Delta Ring or Slip Ring
- USGI Barrel Nut
- Sight Post Assembly, Round or Square Post
- Gas Tube
- Sling Swivel Assembly
- If you order a "Non-F" FSB, we will configure the barrel with a Slip Ring and Round Front Sight Post
- If you order a "F" marked FSB, we will include a Delta Ring and Square Front Sight Post
- If you would like some other combination just let us know in the "Comments Section" at Check-Out
Barrel Specs:
- 10 inches
- 5.56 NATO chamber
- 1:8 twist
- 4150 Steel Barrel
- Mag Phosphate or Nitride Finish
- .750 (M4 profile)
- 1lbs 2oz (nitride) 1lbs 4oz (phosphate)
- Made in the USA
- Lifetime Guarantee
Barrel Assembly Specs:
- "F" or "non-F" Front Sight Base (Tapper pinned)
- Barrel Nut
- Sling Swivel
- Round or Square Front Sight Post
- Gas Tube
- All Parts Made in the USA
- Lifetime Guarantee
* Note on Short Pinning:
If all you want is a Barrel with a Front Sight Base and nothing else (Option 2) we will assume you are using a different type of Barrel Nut. We will then complete 99% of the Tapper Pin job and not pound the two Tapper Pins in tight so you can slide on your Barrel Nut. Once assembled, simply pound your two Tapper Pins in tight and you are done. We have done all the Tapper Pin work for you - you just need to do the last 1% of the job and tighten the pins down.
* Note on Full Assembly:
Everything is assembled and tightened to spec. Simply screw the barrel nut to your receiver, install your Gas Tube and you are Good-To-Go.
